![]() ![]() This creates a CSV file in the Logs directory.įirmware for 6000 series includes built-in flasher utility. In logger mode, logging is started with a press of the Start key and stoped with a press of the Stop key (confirmed with a press of the OK key). In flight mode the flight is recorded as an IGC file in the Tracks directory on the SD card. With this version, press power key to start-up SensBox, chose between "FLY" (flight mode) and "LOG" (data logger mode) with ↑ or ↓ keys and confirm by pressing OK key. This version combines flight and logger functionality into one firmware. Warning: Only one firmware file is allowed in the system folder, otherwise an error message Err will appear when initiating the upgrade sequence above. After the firmware update is complete, the SensBox will automatically switch off. The SensBox will turn ON and the display will show UPG with a moving segment to indicate the upgrade is in progress. To activate the new firmware, hold the OK button while short pressing the power button. Disconnect USB (depending on operating system, chose "eject" or "disconnect safely")ĭownload new firmware ( file) from this page and transfer to the System folder on the SensBox SD card (this can be done directly to the SD card or via the USB connection).In that case, it downloads the update automatically and copies it to the "update" folder on the Element drive The programme connects to our server, checks to see if newer software is available.Open the drive ELEMENT and open the utility Element Update.Connect Flytec Element to computer with USB cable - the Element shows up as a drive ELEMENT. ![]() ![]() Future firmware updates can be automatically installed by launching the utility and following the steps below. Subsequent to installing the v1.04.13 below, Element Update utility is placed in the mass storage of the Element. upg exist in the "update" directory, only the newest one will be offered for installation. upg, this file will be offered for installation again the next time you turn the Element on. The firmware file remains in the "update" folder after the update, but its ending changes from. The Element goes through the update routine and then turns itself off.Confirm question "Update?" with the OK key.Disconnect USB according to computer OS (Eject or Disconnect safely).Copy firmware file to directory "update" on the Element drive.Connect Element to computer with USB cable.Element Instructions v1.03.10 and earlier: ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |